Jb-lighting Licon 1X Manuel d'utilisateur télécharger pdf (Page 82)

JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein Telefon ++49(0)7304 9617-0

- 82 -

16. Editing sequences

In order to edit sequences, proceed as described below:

Press the ESC key time and again until you have entered the

main menu.

Then press the EDIT key in the Combi section (LED is lit).

Select the desired sequence by pressing the corresponding

sequence key.

The following display is shown:.

All parameters of this menu have already been dealt with in

Chapter 15.  Cf. Chapters 15.1 to 15.14

Press the softkey MODIFY and the following menu is shown on the display:

16.1 The BLOCK function

You can combine several sequence steps to a block that can be either deleted or copied afterwards.

If you have, for example, a sequence that consists of 10 steps, you can define steps 2 to 5 as block and

copy this block to another position within the sequence.

You can use the BLOCK function to delete individual steps of your sequence. Define these steps as block

and then press the Delete key.

Defining a block:

A block can be formed of steps that are arranged consecutively in your sequence. Move the cursor in the

PROG COMB CHASE matrix to the first step you wish to integrate in the block. Press and hold the

softkey BLOCK (field on the display is shown inverted). Turn the middle encoder wheel until you have

reached the last step to be integrated in the block. Release the softkey BLOCK again. All steps integrated

in the block are marked with a B on the display.

This process is additionally shown as graph on the display.

The illustration shows that the block of our example contains a total of your steps (step

2 to step 5).

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 128 129

Pas de commentaire

Jb-lighting Licon 1X Manuel d'utilisateur Page 82