Jb-lighting Licon 1X Manuel d'utilisateur télécharger pdf (Page 10)

JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein Telefon ++49(0)7304 9617-0

- 10 -

1. First steps

1.1 Scope of delivery and installation

Lighting control console

Connecting cable

User manual

USB-cable

Optional accessory:

Desklamps

Flightcase

Dustcover

Trackball

Please check whether delivery is complete

Ensure that the voltage complies with the power unit settings and plug in the power unit. The factory

setting of the console is 230 V. After plugging in the controller, the LED of the ON/OFF key is lit. If this is

not the case, throw master switch of the power unit and activate the control console by pressing the

ON/OFF key.

1.2 Changing the input voltage

The input voltage of the Licon 1X is adjusted with a slider situated beneath the mains plug. You can

choose between 230 V and 115 V. Set the required voltage with a suitable tool (e.g. screwdriver) before

you plug in the console. Move the red slider located between the mains socket and the mains plug to the

right (115 V) until it locks, or move it to the left (230 V) until it locks. If no red slider is present on the

power supply unit of the lighting control console, please contact our service team before you carry out the

voltage setting.

1.3 DMX outputs

The Licon 1X has four DMX output sockets. These are 5-pin sockets with the following occupation:

Pin 1  shield

Pin 2  data –

Pin 3  data +

Pin 4  not occupied

Pin 5  not occupied

Since DMX boosters are generally required for very long DMX lines (where many devices are connected),

the Licon 1X is equipped ex works with a DMX booster. This means that two output sockets are available

per DMX line with 512 channels. The output sockets are designated A1 and A2 or B1 and B2,

respectively.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 128 129

Pas de commentaire

Jb-lighting Licon 1X Manuel d'utilisateur Page 10