Jb-lighting Licon 1X Manuel d'utilisateur télécharger pdf (Page 75)

JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein Telefon ++49(0)7304 9617-0

- 75 -

14. Editing a chase in the Combi section

The parameters of a chase can only be edited in the Edit Chase menu (press Edit key in the Combi

section) with the exception of the manual modification of the chase speed, which is performed in the

Chase Control section.

The Edit Chase menu display has the following structure:

If you have entered the Edit Combi Chase menu, select the

desired chase step with the middle encoder wheel (STEP).

14.1 The LINK F function

Use the softkey LINK F to select whether the fade time is processed in absolute numbers, i.e. in seconds,

or as percentage values depending on the NextTime.

LINK F inverted: in percent

LINK F not inverted: in absolute numbers

14.2 The SINGLE function

Use the softkey SINGLE to enter whether the chase runs permanently as loop or only once.

SINGLE inverted: chase stops after the last chase step

SINGLE not inverted: chase runs permanently as loop

14.3 The FLASH function

The FLASH function can only be used in combination with a release link. If a FLASH function is assigned

to a chase, this chase is only active as long as the chase key is pressed.

Enter the release link as described in Chapters 6.1.7 and 6.1.8.

Use the softkey FLASH to activate the FLASH function.

FLASH inverted: function is active

FLASH not inverted: function is deactivated

14.4 The NAME function

Use the NAME function to name the chase. If the NAME function is activated, name the chase with the

keys of the CUE/CHASE/SEQUENCE section.

NAME inverted: function is active

NAME not inverted: function is deactivated

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 128 129

Pas de commentaire

Jb-lighting Licon 1X Manuel d'utilisateur Page 75