Jb-lighting Licon 1X Manuel d'utilisateur télécharger pdf (Page 72)

JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein Telefon ++49(0)7304 9617-0

- 72 -

13. The Chase Control section

The Chase Control section allows direct access to active chases and speed groups.

The speed of a chase is indicated by the yellow LED incorporated in the chase key. You can change the

speed of a chase manually in the Chase Control section, indpendent of the speed data previously

programmed. The speed changed by means of the Chase Control Section will overwrite the data

programmed previously. The following control elements are available to enter data:

Encoder-wheel (SPEED): for manual speed regulation.

Restart key: resets chase to the first chase step (when key is

pressed simultaneously with the corresponding chase

key).

Select key: activates chases.

Learn key: regulates speed by tapping the desired speed with the

key.

Sync key: not occupied.

Direction key: changes chase direction.

Sound key: for music control.

Go - key: manual stepping of the chase, against the direction

of the chase.

Go + key: manual stepping of the chase, in direction of the

chase.

Go key: stops the chase and allows manual stepping with the

Go + und Go - keys.

13.1 Activating a chase for speed regulation

Press and hold the Select key in the Chase Control section. Press the chase key in addition, on which the

desired chase is stored. Now you have direct access to the activated chase and can modify its

parameters with the above listed control elements.

13.2 Changing speed with the encoder wheel (SPEED)

After successful activation of the chase as described in13.1, it is possible to progressively regulate the

speed with the encoder wheel (SPEED). The speed range can be adjusted from 0.0500 seconds to

819.18 seconds.

You can change the speed at intervals of 0.0125 seconds by turning the inner ring of the encoder wheel

(SPEED).

By turning the outer ring of the encoder wheel, the intervals become greater, depending on how far the

ring is turned to the left or right.

13.3 Changing speed with the Learn key

Activate the desired chase as described in 13.1.

Then press the Learn key two times at the speed, at which the steps are intended to run (e.g. to the

rhythm of a music track). The time interval will be adopted that elapses while the LED is blinking. The

chase immediateley runs at the new speed. The blinking intervals of the yellow LED show the speed, at

which the chase runs.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 128 129

Pas de commentaire

Jb-lighting Licon 1X Manuel d'utilisateur Page 72